KROHNE CORIMASS G-MFM 4085 EN - Manual (Page 51)

51
5.5 Programming Numeric Data
Various functions on the MFC 085 require numeric data to be entered by the operator. Numeric
data is always entered in the following manner.
Using setting FULL SCALE of current output, Fct. 1.3.3 as an example:
Begin from the measuring mode:
Return to measuring mode
∗
The flashing '0' to the left of the number to be edited allows extra digits to be added, as in
this example. If no extra digits are required, pressing the
→
key will cause this leading zero
to be blanked.
(0)5.0000 kg/min
→
(5).0000
∗∗
Some values do not allow the decimal point to be moved.
Key Display
line 1 line 2
→
Fct. (1).0 OPERATOR
→↑↑
Fct. 1.(3).0 CUR.OUTP. I
→↑
Fct. 1.3.(2) MIN. FLOW
(assume function is set to
MASS FLOW)
↑
Fct. 1.3.(3) MAX. FLOW
→
(0)
*
5.0000 kg/min
Current setting of MAX.FLOW
Units and accuracy are as
set by the format Fct. 1.2.1
↑
(1)5.0000 kg/min
→
1(5).0000 kg/min
5x
↑
1(0).0000 kg/min
→
10(.)
**
0000 kg/min
Decimal point may now be
moved one digit to the right for
each press of the
↑
key
→↑
10.(1)000 kg/min
↵
Fct. 1.3.(3) MAX FLOW
4x
↵