KYORITSU 6300 Quick Manual - Manual (Page 12)

5.1 Display screen modes (6-1, 6-2)
Three parameters are displayed on one screen as shown below. (On Screen 1-A:
V/ A/ P) Display screens vary depending on the wiring configuration.
● In case of a Three-phase 4-wire “3P4W” (15 screens)
Screen name: Screen 1-A
X Axis
A B C D E F G
Screen name Y Axis (1-A) (1-B) (1-C) (1-D)
Upper
V
V1 V2 V3
Middle
1
A
A1 A2 A3
Lower
P
P1 P2 P3
- - -
Screen name (2-A) (2-B) (2-C) (2-D)
Upper P P1 P2 P3
Middle
2
S S1 S2 S3
Lower PF PF1 PF2 PF3
- - -
Screen name (3-A) (3-B) (3-C) (3-D) (3-E) (3-F) (3-G)
Upper V1 A1 P1 PF1 S1 Q1 f
Middle
3
V2 A2 P2 PF2 S2 Q2 In
Lower V3 A3 P3 PF3 S3 Q3 -
* Screen 1-A appears on switching on the instrument .
* Pressing or key displays the screens along the X axis of the above table.
(eg. from Screen 1-A to 1-D, Screen 2-A to 2-D, Screen 3-A to 3-G)
* Pressing or key displays the screens along the Y axis of the above table
Pressing key whilst on any Screen 1, displays screen 3-A, and 2-A by pressing
key.
Pressing key whilst on any screen 2, displays screen 1-A, and 3-A by pressing
key.
Pressing key whilst on any screen 3, displays screen 2-A, and 1-A by pressing
key.
* On the display screen, , , correspond to the respective phase .
(e.g. On Screen 1-B, and on Screen 3-A, all , , are displayed.
On Screen 1-A, 2-A and 3-G, the numbers will not be displayed.)
Upper : V
Middle : A
Lower : P
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
− 10 −