KYORITSU 6300 Quick Manual - Manual (Page 16)

When measurement ends
(close a file)
, the mark disappears and LED status
Indicator goes off.
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
Make setting at Setting 10 & 11
Press the key.
Press the key.
(at least for 2 sec.)
Press the key.
(at least for 2 sec.)
6.1 Measurement execution (7-1, 7-2)
●Manual mode ●Automatic mode (setting the date and time)
Wh range
* In case the data to be saved to the internal memory, the mark is displayed instead of the
mark.
* Ensure that the file is closed. Data will not be saved unless a file is closed.
Following a measurement, integration value is still shown on the display screen.
When the value is not requires for the subsequent measurement, reset (7-3) the
integration value by pressing the key for at least 2 sec. and select “dEL”, or at
“Setting 12”.
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
File number screen is displayed for about 2sec.
(open a file)
* Start measurement manually.
* When automatic measurement is set, the instrument goes into
stand-by mode and measurement starts at the set time & date.
In stand-by mode, both LED status indicator and the mark
flash. Both indicators are displayed when measurement starts.
Measuring
Start
Displayed
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
Flashing
Stand-by
* Indicated value is refreshed every 1 sec.
* Data is saved at the interval, which is pre set
at “Setting 09”.
* During a measurement, instantaneous value
can be viewed on W range and settings
can be viewed on SET UP range.
Stop
Displayed
Automatic operation Manual operation
Wh range
Measurement ends at set time & date
− 14 −