KYORITSU 6300 Quick Manual - Manual (Page 19)

Stop
* Indicated value is refreshed every 1 sec.
* Data is saved at the interval, which is pre set
at “Setting 13”.
* During a measurement, instantaneous value
can be viewed on W range, integration
value on Wh range and settings can be
viewed on SET UP range.
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
Make setting at Setting 14 & 15
Press the key.
Press the key.
(at least for 2 sec.)
Press the key.
(at least for 2 sec.)
DEMAND
range
Measurement ends at set time & date
When measurement ends
(close a file)
, the mark disappear and LED status
Indicator goes off.
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
7.1 Measurement execution (8-3, 8-4)
●Manual mode ●Automatic mode (setting the date and time)
DEMAND
range
* In case the data to be saved to the internal memory, the mark is displayed instead of
the mark.
* Ensure that the file is closed. Data will not be saved unless a file is closed.
After a measurement, demand value is kept indicated on the display screen.
Demand value is reset (8-5) by pressing the key for at least 2 sec. and select
“dEL”, or at “Setting 18”.
File number screen is displayed for about 2sec.
(open a file)
* Start measurement manually.
* When automatic measurement is set, the instrument goes into
stand-by mode and measurement starts at the set time & date.
In stand-by mode, LED status indicator and the mark flash.
Both are displayed when measurement starts.
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
Displayed Flashing
‣‧•⁈ ‥••⁈ ••⁈ ‣⁂․⁉ ‣⁂‥⁉ ‥⁂‥⁉ ‥⁂…⁉
‧″ ‣•″ ․•″ ‧•″ ‣••″ ․••″ ‧••″ ‣•••″
Displayed
Start Stand-by
Measuring
Automatic operation Manual operation
− 17 −