KYORITSU 6300 Quick Manual - Manual (Page 18)

Safety first!
Turning on the instrument
Basic setting
Wiring
Confirmation of
instantaneous value
Setting for demand
measurement
Demand value
measurement
DEMAND range
7. Demand value measurement: DEMAND range
(Section 8)
● Measurement flow chart
● Displayed items on DEMAND range
Displayed parameters Unit
Target value W
Predicted value W
Present value W
Load factor %
Remaining time -
Max. demand value W
Date and time when max. demand value measured -
SET UP range
“Setting 13” Demand interval
“Setting 14” Demand start time & date
(to start measurement at set time & date)
“Setting 15” Demand stop time & date
(to stop measurement at set time & date)
“Setting 16” Demand target value
“Setting 17” Demand inspection cycle
“Setting 18” Reset of demand value
W range
SET UP range
“ Setting 01” Wiring
“ Setting 02” Voltage range
“ Setting 03” Current range
“ Setting 04” Clamp sensor
“ Setting 05” VT ratio (if necessary)
“ Setting 06” CT ratio (if necessary)
− 16 −