Martel Electronics PSC4010 - Manual (Page 16)

14
4.5 Sourcing volts
To source volts follow these steps:
1. Select the [CONFIG] option from the main menu.
2. Choose [VOLTS] from the primary parameters. Switch to input/output control and select
output [OUT].
3. Connect the leads for the voltage source terminals, as shown in Figure 11.
4. Enter the voltage using the keypad.
4.6 Sourcing millivolts
To source volts follow these steps:
1. Select the [CONFIG] option from the main menu.
2. Choose [mV] from the primary parameters. Switch to input/output control and select output
[OUT].
3. Connect the leads for the voltage source terminals, as shown in Figure 11.
4. Enter the millivolts value using the keypad.
Figure 11. Connections for Sourcing Voltage and Frequency
0.00% mA 2W SIM
MENU
4.000 mA
STEP LIGHT
–
+
UUT
MEASURE / SOURCE
3W
mA+ +
V
Hz
–
Ω
4W
mA–
VOLTS OUT
MENU
0.000 V
LIGHT STEP