Martel Electronics DMC1400 - Manual (Page 41)

InH2O4C Pressure in inches of water at 4°C
InH2O20C Pressure in inches of water at 20°C
CmH2O4C Pressure in centimeters of water at 4°C
CmH2O20C Pressure in centimeters of water at 20°C
Bar Pressure in bars
Mbar Pressure in millibars
KPal Pressure in kiloPascals
InHg Pressure in inches of mercury at 0°C
MmHg Pressure in millimeters of mercury at 0°C
Kg/cm2 Pressure in kilograms per square-centimeter
Table 8: Error codes
Error Number Error Description
100 A non-numeric entry was received where it should be a numeric entry
101 Too many significant digits entered
102 Invalid units or parameter value received
103 Entry is above the upper limit of the allowable range
104 Entry is below the lower limit of the allowable range
105 A required command parameter was missing
106 An invalid pressure unit was received
107 An invalid CJC_STATE was received
108 An invalid TSENS_TYPE was received
109 Pressure module not connected
110 An unknown command was received
111 An invalid RTD or TC parameter value was received
112 The serial input buffer overflowed
113 Too many entries in the command line
114 The serial output buffer overflowed
115 Output is overloaded
116 Calibrator not in pulse train mode when TRIG was received
117 An invalid FREQ_TYPE was received
7.5 Entering Commands
Commands for the calibrator may be entered in upper or lower case.
There is at least one space required between the command and
parameter, all other spaces are optional. Almost all commands for
the calibrator are sequential, any overlapped commands will be
indicated as such. This section will briefly explain each of the
commands and describe their general use, which will include any
39