NSi Industries DGM100A - Manual (Page 11)

9
4 . DATE MODE: Press MONTH, DATE and YEAR to
modify existing settings . Press ENTER to save
changes . DAY is automatically adjusted .
5 . DSt MODE: Factory default is set at US standard
daylight savings dates noted by ON . To remove
daylight savings time setting, press DEL to
change screen to show OFF . DST may be activated
again by pressing DEL . Press ENTER to save
changes . To change from the standard DST month/
week/day setting press HOUR and refer to step 4 .1 .
6 . HOLIDAY MODE: Press ENTER to advance to
desired holiday . Press MONTH and DATE to modify
start of holiday (ON) then press ENTER . Press
MONTH and DATE to modify end of holiday (OFF)
then press ENTER to save changes .
7 . SCH MODE: To change schedule, press ENTER to
advance to desired event . Press HOUR, MIN, EVENT,
and DAY to modify time settings . Press DEL to delete .
Press ENTER after each modification to save changes .
NOTES:
1 . Unit has a look back feature . Press the EVENT key
once (or twice for two circuit units) to activate current
schedule then EVENT key again to return to the
time (run) screen . Unit will automatically pick up the
last schedule .
2 . To clear date and time only and provide unit with
a soft reboot, press and release the reset button that is
recessed under the small hole to right side of LCD
screen .
3 . Clear all memory . To clear all memory, while in the
RUN mode, press ENTER, display will show: