NSi Industries DGM100A - Manual (Page 3)

1
TORK MODEL
DG100A/DGM100A/DG200A
7 DAY DIGITAL TIME SWITCH
READ INSTRUCTIONS CAREFULLY BEFORE
ATTEMPTING TO INSTALL TIME SWITCH. SEE
WARNING ON FRONT PANEL – Failure to comply with
instructions could result in personal injury and/or property
damage .
INSTALLATION:
UNIT IS TO BE INSTALLED BY A LICENSED ELECTRICIAN
1 . Remove unit from enclosure by pushing the inside
tab (located near the outside hasp) to the right .
Swing unit to left and remove .
2 . Mount the enclosure at eye level using screws
or other suitable fastening device . Bring supply
and load wires in through or side knockouts .
DO NOT USE TOP .
3 . Reinstall unit by reversing step #1 above and
connecting wires to units as per suggested
wiring diagrams at back of manual .
4 . Unit should be programmed with AC power . Do
not program under super cap back up power .
AT POWER UP;
Connect unit to main power source prior to entering the
settings . When powering up the unit for the first time,
allow 1-2 minutes for super cap to charge and the
display will show 12 HOUR . Press reset button after 2
minutes if screen is blank .
CAPABILITIES
- 7 day scheduling
- 56 set points
- 9 Block holidays