NSi Industries DZS400BP - Manual (Page 7)

The display will only show the last scheduled event for
CH1. To view the last schedule event for other channels,
simply press the EVENT key again. If there is no sched-
ule programmed for a specific channel, the display will
show —:—
10.1 NOTES:
1. Unit will go to RUN MODE automatically if no
key is pressed for 5 minutes.
2. Unit has a look back feature. If you have just
finished setting the unit and an output is to be
updated, press the EVENT key. Unit will auto-
matically pick up the last schedule.
3. Clear all memory. To clear all memory, while in
the RUN mode, press ENTER, display will
show:
Press EVENT, the display will show:
Press ENTER briefly and everything in the timer
memory is wiped off including real time and date.
12HOUR will flash.
11.0 COPY PROGRAM SETTINGS TO ANOTHER
MEMORY MODULE (FOR BP MODELS ONLY)
WARNING: DO NOT USE UNIT AS COPIER
WHILE PROGRAM SETTINGS ARE ACTIVE.
DOING SO WILL TURN OFF ANY CONNECT-
ED LOADS.
Follow steps below:
-
Take unit out of enclosure
- Locate the copy switch (red switch labeled
BP01)
- Put the switch on the ON position
- Place unit back in enclosure
- Connect power cord
- Put back insulator that covers the terminal
block. Make sure no terminals are exposed to
the operator.
12
If daylight savings is required, press ENTER, dis-
play will show:
Press ENTER to accept default dates (second
Sunday in March) or press MONTH, DATE, and
DAY to modify DST settings and press ENTER.
The display will show:
Press ENTER and the display will show:
Press ENTER to accept default dates (first Sunday
in November) or press MONTH, DATE, and DAY to
modify DST settings and press ENTER. Press
MODE, the display will show:
NOTE: DST OFF indicates Daylight Savings Time
was not set.
4.0 SEASON DURATION SET
Up to 4 different season durations can be set by
entering the START and END dates.
5
DTS400B - DZS400BP 3/9/07 10:17 AM Page 13