NSi Industries DZS400BP - Manual (Page 8)

5. HOLIDAY MODE: Press ENTER to advance to
desired Holiday. Press MONTH and DATE to
modify, DEL to delete. Press ENTER.
6. SIGNAL MODE: Press ENTER to advance to
desired channel. Press SIG/SEC to modify,
DEL to delete. Press ENTER.
7. SCHEDULE MODE: Press ENTER to advance
to desired channel. Press HOUR, MIN, EVENT
(SIG1/SIG2) to modify time settings. Press
SELCT and DAY to modify days, holiday and/or
seasons, DEL to delete. Press ENTER after
each modification.
8. ASTRO MODE: Press SELCT to select desired
channel. Press LAT to change latitude. Press
ENTER. Press DAY and SELCT to add or
delete days in the sunset mode. Press ENTER.
Press HOUR and/or MIN to change offset time
for sunset. Press EVENT to change offset from
+ to –. Press ENTER and follow the same pro-
cedure above to modify or review sunrise set-
tings.
9. RUN MODE: Time, day and seconds are dis-
played. If today is a programmed holiday, an H
(Holiday) will be displayed steady. If today falls
within a programmed season that season # will
be displayed.
10.0 OVERRIDE
OVRDE1 to OVRDE4 (override keys) are effective
only in the run mode. If a channel is scheduled for
ON/OFF (non-signal timer), then the channel will
change the present load status until the next
scheduled event. CH# will flash when the load is
overridden from scheduled event.
NOTE: If a channel is a signal timer, then the load
will turn on each time the override key is pressed
for the length of SIG1 duration. Ch# will flash while
the load is on. While the signal is in progress, it can
be terminated by using the override key.
EVENT (in the RUN mode) key is used to update the
load status. It will execute the last scheduled event for all
channels.
11
NOTE:
1.
If season durations are not set, they will not
appear on the schedule and astronomic mode.
2. Each season can be set up to 364 days.
3. Any season can cross the year boundary, i.e.,
the current year and end the next year.
4. When any two or more seasons overlap, the
higher numbered season has priority.
Press MODE until display shows:
Press MONTH and DATE to set the starting period
of season 1 and then press ENTER. The display
will show:
Press MONTH and DATE to set the ending period
of season 1 and then press ENTER. Follow the
above procedure to set all other 3 seasons, if
d e s i r e d . To delete any entry press DEL a n d
ENTER.
NOTE: For any season to be used, the starting
MONTH, DATE and ending MONTH, DATE must
be preset.
5.0 SET INDIVIDUAL HOLIDAY DATES
Press MODE until display shows:
6
DTS400B - DZS400BP 3/9/07 10:18 AM Page 15