NSi Industries ELC72 - Manual (Page 6)

4
4 .0) EVNT – Set ON time at 4:00pm and OFF time
(example: 11:30pm)
5 .0) INPT - Skip
6 .0) EVNT SENS - Skip
7 .0) HOL - Set holidays as required or skip
8 .0) RUN – Update schedule for operation
E: Photo ON and OFF
1 .0) TIME – Set time, date, daylight savings time dates
2 .0) CONF – Skip
3 .0) ASTR – Skip
4 .0) EVNT – Skip
5 .0) INPT - Configure input wired with photo sensor
6 .0) EVNT SENS – Set sensor event for 12:00am ON
7 .0) HOL - Set holidays as required or skip
8 .0) RUN – Update schedule for operation
F: Photo ON and Time OFF
1 .0) TIME – Set time, date, daylight savings time dates
2 .0) CONF – Skip
3 .0) ASTR – Skip
4 .0) EVNT – Set OFF time (example: 11:30pm)
5 .0) INPT - Configure input wired with photo sensor
6 .0) EVNT SENS – Set sensor event for 9:00am ON
7 .0) HOL - Set holidays as required or skip
8 .0) RUN – Update schedule for operation
0.0 INITIAL POWER-UP OR RESET
The control will display MEM CLR (memory clear) .
This is only accessible once . It indicates that the
memory has been cleared .
Use the NEXT key to begin set-up .
0.1 CONTACT OPERATION
Toggle between MAINTAIN (maintained) or
MOMENTARY operation using the +/- key .
Note: The ELC71 & ELC72 will normally be