NSi Industries ELC72 - Manual (Page 9)

7
The following stagger-up selections are available:
NO = not used
00 .05 = 5 seconds
00 .15 = 15 seconds
00 .30 = 30 seconds
01 .00 = 1 minute
05 .00 = 5 minutes
10 .00 = 10 minutes
15 .00 = 15 minutes
Note: The selected stagger up time between channels
occurs at scheduled ON events, after a power outage,
and after a status update .
Use the NEXT key advance .
2.3 SET DURATION LENGTH (SIGNAL) AND DUTY
CYCLE
Use the + and - keys to modify the flashing item .
Use the NEXT key advance to the next flashing item .
Program dUR1 (first duration 0:00 .01) hour, minutes, or
seconds and continue to set each of the durations
(dUR2 – dUR4 .)
Note: These durations are programmable from 1
second to 23 hours, 59 minutes and 59 seconds .
Program dCF1 (first duty cycle OFF time) hours, minutes,
or seconds, then program dCN1 (first duty cycle ON
time) hours, minutes, or seconds to complete the pair .
Continue for each of the duty cycles (dCF2 – dCF4) .
Note: The off cycle is programmable from 1 second
to 23 hours, 59 minutes and 59 seconds . The control
will not allow an off cycle of 0:00 .00 . A duty cycle
event will always start with the off cycle .
Press the PROGRAM key to go to next mode .