Pyromation Series 610 1_16 DIN - Manual (Page 51)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Parameter Lower
Display
Upper
Display Description Default
Value
When
Visible



Decimal point
position =) -

Decimal point position in
non-temperature ranges.
0 = XXXX
1 = XXX.X
2 = XX.XX
3 = X.XXX
 %C@.
 =
mV, V or
mA

-C#' Primary control  Control Type 3.4)
=1 ' Primary and Secondary
control (e.g. for heat & cool)
-C#' Always
+!1 Reverse Acting Primary Output
Control Action 3.*'
=+ Direct Acting
+!1 Always
):$ Process High Alarm
):' 
Process Low Alarm
= 
Deviation Alarm
 C= Band Alarm
Alarm 1Type ' 
C C  No alarm
):$ Always
Process High
Alarm 1 value* )? 
Range Min. to Range Max.
Parameter repeated in Setup Mode Range
Max.
' =
):$
Process Low
Alarm 1 value* )' 
Range Min. to Range Max
Parameter repeated in Setup Mode
Range
Min.
' =
):' 
Deviation
Alarm 1 Value* = '
±span from setpoint
Parameter repeated in Setup Mode
 ' =
= 
Band Alarm 1
value* 1 LSD to full span from setpoint.
Parameter repeated in Setup Mode

' =
 C=
Alarm 1
Hysteresis*
$4
1 LSD to 100% of span (in display units)
on “safe” side of alarm point.
Parameter repeated in Setup Mode

Always
Alarm 2 Type
' 
As for alarm 1 type
):' 
Always
Process High
Alarm 2 value*
)? 
Range Min. to Range Max.
Parameter repeated in Setup Mode Range
Max.
' =
):$
Process Low
Alarm 2 value* )' 
Range Min. to Range Max.
Parameter repeated in Setup Mode Range
Min.
' =
):' 
Deviation
Alarm 2 Value* = '
±span from setpoint.
Parameter repeated in Setup Mode
 ' =
= 
Band Alarm 2
value*  '
1 LSD to full span from setpoint.
Parameter repeated in Setup Mode
 '  =
 C= 
Alarm 2
Hysteresis* $4
1 LSD to 100% of span (in display units)
on “safe” side of alarm point.
Parameter repeated in Setup Mode
 Always
Loop Alarm
Enable ' C =, (disabled) or
C  (enabled) =,  Always
 '
Page 46
P6100, P6120, P8100 & P4100 Model Group 59305, Issue 6 – March 2006