Pyromation Series 610 1_16 DIN - Manual (Page 95)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Parameter Lower
Display
Upper Display
Adjustment Range
Default
Value
When
Visible
Process High Alarm 1
value* )?  Range Min. to Range
Max. Range
Max.
' 
=
):$ 
Process Low Alarm 1
value* )'  Range Min. to Range
Max. Range
Min.
' 
=
):' 
Deviation Alarm 1
Value* = ' ±span from setpoint  ' 
=
=
 ' 1 LSD to full span from
setpoint. 
Up to 100% of span 
)?  Range Min. to Range
Max. Range
Max.
'  = ):$ 
)'  Range Min. to Range
Max. Range
Min.
'  = ):' 
Deviation Alarm 2
Value = '
±span from setpoint
 '  = = 
Band Alarm 2 value*  ' 1 LSD to full span from
setpoint.  '  =  C= 
Alarm 2 Hysteresis*
$4
Up to 100% of span
 Always
Set-up Lock Code
-' N
0 to 9999
 Always
**First Operator mode displays follows.

Band Alarm 1 value* '  =  C= 
Alarm 1 Hysteresis* $4 Always
Process High Alarm 2
value*
Process Low Alarm 2
value*
Note:
Alarm parameters marked * are repeated in Configuration Mode.
Note:
**Once the complete list of Set Up Mode parameters has been displayed, the first
Operator Mode display is shown without exiting from Set Up Mode.
CAUTION:
An excessively large filter time could significantly delay detection of a limit
condition. Set this value to the minimum required to remove noise from the process
variable.
Page 90
P6700, P8700& P4700 Model Group 59305, Issue 6 – March 2006