Pyromation Series 610 1_16 DIN - Manual (Page 57)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Parameter Lower
Display
Upper Display
Adjustment Range
Default
Value
When
Visible
Output 2
Cycle Time 3. 0.5, 1, 2, 4, 8, 16, 32, 64,
128, 256 or 512 secs.
Not applicable to linear
outputs  0-  
=
)+

or -!N 
or
1,
Output 3
Cycle Time 3. 0.5, 1, 2, 4, 8, 16, 32, 64,
128, 256 or 512 secs.
Not applicable to linear
outputs  0-  
=
)+

or -!N 
or 1,
Process High Alarm 1
value* )?  Range Min. to Range
Max. Range
Max.
'  = ):$ 
Process Low Alarm 1
value* )'  Range Min. to Range
Max. Range
Min.
'  = ):' 
Deviation Alarm 1
Value* = ' ±span from setpoint  '  = = 
Band Alarm 1 value*  ' 1 LSD to full span from
setpoint.  '  =  C= 
Alarm 1 Hysteresis* $4 Up to 100% of span  Always
Process High Alarm 2
value* )?  Range Min. to Range
Max. Range
Max.
'  = ):$ 
Process Low Alarm 2
value* )'  Range Min. to Range
Max. Range
Min.
'  = ):' 
Deviation Alarm 2
Value = '
±span from setpoint
 '  = = 
Band Alarm 2 value*
 '
1 LSD to full span from
setpoint.

' 
=
 C= 
Alarm 2 Hysteresis*
$4
Up to 100% of span
 Always
Loop Alarm Time*
' .
1 sec to 99 mins. 59secs.
Only applies if primary
proportional band = 0
 ' C =
C  
Auto Pre-tune enable /
disable
).
=- disabled or
C  enabled
=-  Always
Manual Control select
enable / disable
) C
=- disabled or
C  enabled
=-  Always
Setpoint Select shown
in Operator Mode,
enable / disable
-- C
=- disabled or
C  enabled
=-  Slot A or B fitted
with RSP module
Setpoint ramp shown in
operator mode, enable /
disable
-@+
=- disabled or
C  enabled
=-  Always
SP Ramp Rate Value
+)
1 to 9999 units/hour or Off
(blank) Blank

Always
Page 52
P6100, P6120, P8100 & P4100 Model Group 59305, Issue 6 – March 2006