Revo RESPTZ37-1/HSC/HSW User Manual - Manual (Page 13)

REVO America www.revoamerica.com RESPTZ37-SERIES
11
The following settings are used for the Alarm function enable/disable (S4-1), PAL/NTSC selection
(S4-2), and RS-422/RS-485 selection (S4-4). Set the switches as indicated in the table below.
S/W On Off F UNCTION
D1 S4-1 Enable
Disable Alarm
D2 S4-2 PAL NTSC NTSC/PAL
D3 S4-3 Default Reserved
D4 S4-4 RS-422 RS-485 RS-422/RS-485
The following settings are used to set the protocol the camera will use to communicate with the
video controller. If you are using a keyboard controller or DVR other than REVO America, check
the protocol required and set switch S5 as follows:
D5 D6 D7 D12
P ROTOCOL
S5-1 S5-2 S5-3 S6-4
Off Off Off Off
F2,REVO TRAX,
Pelco-D,Pelco-P(Default)
Off Off On Off F2,REVO TRAX
Off On Off Off Sensormatic RS422
Off On On Off Pelco-D, Pelco-P
On Off Off Off Vicon
On Off On Off Ernitec
On On Off Off Reserved
On On On Off F2
Off Off Off On Philips(Bosch)
Off Off On On Reserved
Off On Off On Dynacolor
Off On On On Reserved
NOTE
Some of the camera features may not be available when using protocols other than the
defaults listed above.