Revo RESPTZ37-1/HSC/HSW User Manual - Manual (Page 33)

REVO America www.revoamerica.com RESPTZ37-SERIES
31
NOTE
When the flip mode is set to 90°, 100°, 110°, 120° the camera will flip when it reaches
the preconfigured setting. This will cause the camera to appear to pan in the opposite
direction as the control arrows.
FLIP: OFF/AUTO/90°/100°/110°/120°.
OFF: The dome camera moves until it reaches 90° vertically.
AUTO: When the camera reaches the floor directly above the moving
object, it stops. At that time, release the joystick instantly and pull it
down again to run the auto-flip function. If you are using the Panning
Range function, set the Flip mode to AUTO.
90°/100°/110°/120°: Allows the image to flip digitally when the camera
moves over the setting angle vertically.
TILT OVER ANGLE: This option is used to set the limit of the horizontal view angle so that the
trim ring or ceiling does not obstruct the horizontal image when zooming
out (wide angle).
ON: In some installations it is desirable for the dome camera to be able
to see above the horizon. When this option is chosen, the dome will tilt
up over the horizon (about 10 °). When the lens is zoomed out, you can
see the ceiling line. When the lens is zoomed in, the viewing angle is
narrower, and the ceiling line disappears.
Without Bubble: This option will limit the tilt range of the camera to
show the horizon so that the picture shows part of the ceiling line.
With Bubble: The tilt range of the camera is limited to see below the
horizon (10 °).
If Over Angle is not sufficient enough to avoid ceiling obstructions, adjust
the Origin Offset of tilt angle.
See the Origin Offset section that follows for
more information. .
INITIALIZE DATA The Initialize Data submenu will allow you to reset some or all of the
factory default settings and erase any programming that you have
done.
CAUTION
Use care when accessing the Initialize Data menu. Depending upon your selections, it
will erase all your custom settings.