SHIMPO 921A - Manual (Page 26)

TRICOR Systems Inc.
5.2
5.1.2 Resistance Offset (Resistance Option Only)
This step allows adjusting the resistance offset electronics and verifying the
internal resistance gain calibration value, as well as, verifying the resistance
readings.
Appendix C provides the detailed instructions for adjustment/verification of
the resistance electronics.
If the operator wants to proceed to a different service mode step, press
TEST/READY, as required.
5.1.3 Lamp Test
This step allows verifying that the PASS, FAIL, READY, and CAL indicators
are operational. Pressing the CAL switch will alternately turn all these
indicators on and off.
If the operator wants to proceed to the next service mode step, press TEST/
READY, as required.
5.1.4 Resistance CCA Code/Switch Installed (Resistance Option Only)
This step displays the Resistance CCA code (RCCA) value and the switch
installed status. The RCCA code indentifies the specific optional Resistance
CCA type installed in the unit. If the Generic Nest Assembly is connected to
the unit, the SW Install Status should indicate TRUE; if it is disconnected, it
should indicate FALSE.
If the operator wants to proceed to the next service mode step, press TEST/
READY, as required.
5.1.5 Pressure Code
This step displays the Pressure (Force) Transducer Code value. The
Pressure Code identifies the specific transducer type installed on the unit.