SHIMPO 921A - Manual (Page 7)

TRICOR Systems Inc.
1.6
TABLE 1-2
CONTROLS AND INDICATORS (Cont.)
E - Back Panel Resistance Connector J2 (optional) — the electrical
resistance connector used with the resistance cable PN 921-112 to
connect 921A to generic or user nests.
F - TEST STATUS PASS Indicator — illuminates green after a test
cycle in which the device being tested passes all of the specified
parameters (within tolerance).
G - TEST Switch / READY Indicator — has two functions:
1) The READY indicator illuminates when the 921A is ready for
another device test sequence. The indicator extinguishes when a
test sequence is initiated or if the 921A is not ready to accept a
device for test.
2) The TEST switch is a pushbutton switch which, when illuminated,
is pressed to initiate a test sequence. This switch is also used to
initiate a calibration cycle when the 921A is in Calibration Mode.
NOTE: The READY indicator does not indicate when to press the TEST
switch. Its function is only to indicate that the 921A is ready for
another test cycle.
H - TEST STATUS FAIL Indicator — illuminates red after a test
sequence in which a device fails one or more of the specified test
parameters (out of tolerance).
I -MODE Switch / CAL Indicator — has two functions:
1) The MODE switch is used to initiate a calibration cycle.
2) The CAL indicator illuminates green when the 921A is in the
Calibration Mode.