SHIMPO 921A - Manual (Page 4)

TRICOR Systems Inc.
1.3
The test sequence is initiated by pressing the TEST switch or externally by the
PC. During the test sequence, sensor data is logged in 921A memory. Test
data is then analyzed, parameters are calculated, and the results are
compared with the configuration criteria to determine a pass or fail status. The
PASS or FAIL indicator then illuminates. Upon completion of the test
sequence, the 921A is ready to test the next device.
The 921A stores test criteria for one device configuration and up to 32 test
results (PC operating mode) in non-volatile memory so that once loaded the
station will retain the test criteria even upon power-down. Device
configurations are identified by device part numbers. The operator's display
indicates which device is currently being tested by displaying the part number
of the device in the left-hand corner of the display.
For a complete description of operating modes, configuration parameters, test
results, test algorithms and the details for creating configurations and viewing
results, refer to the DFR Operations Software Manual.