SUOMY Jet 70s - Manual (Page 13)

ENG
12
The use of non original components and/or accessories make the warranty void (see warranty conditions on page 16) and can affect
the safety requirements.
To clean the shell use water and mild soap; let the helmet dry at room temperature, never expose it to heat.
Cleaning the helmet with solvents, petrol by-products or chemical substances, applying stickers or painting the helmet could affect the structure
of the shell, thus affecting the safety features, even if the damage is not readily visible. Do not apply stickers to, use petrol or other chemical
solvents with this helmet.
To clean the internal lining use a damp cloth and mild soap only. Let the treated parts dry at room temperature away from direct sunlight and
never expose them to heat.
Periodically clean the restraint system with warm water and mild soap. Do not use solvents or chemical detergents and do not lubricate.
Clean the polycarbonate visor first rinsing it under running warm water. Use mild liquid detergent to wash it; dry using a soft and delicate cloth.
During cleaning operations, carefully handle the visor to avoid damaging the anti-scratch coating. Never use solvents, alcohol, fuels, thinning
substances or abrasive powders; these materials are aggressive and could affect the structural resistance of the polycarbonate or scratch the
surface of the visor with consequent reduction in the mechanical and optical properties.
All painted surfaces are subject to a natural alteration due to exposure to atmospherics; particularly some colourings made with Fluo or UV paints
could be subject to a faster migration phenomenon with a drop in intensity. The phenomenon could be enhanced when the helmet is exposed
for long periods to a particularly intense light. Suomy therefore, cannot be held responsible for alterations of the painted surfaces due
to wear (effects of sunlight, vapours, detergents, crashes, scratches).
This does not jeopardize the performances and the quality of SUOMY JET 70’S.
Adjust the fastening system so that when the helmet is fastened, the strap presses close against the jaw and there are the following conditions:
-
The helmet can no longer be taken off
- By pulling the helmet from the back and rotating it towards the front, the helmet cannot be removed and it remains well fixed on
your head
If the helmet tends to slide off or rotates freely on the head, adjust the strap again until the right pressure is obtained and repeat the test.
If after repeating the test you are not able to efficiently tighten the retention system, do not use the helmet.
After adjusting the length of the strap make sure the end part of the strap is correctly positioned in the adjustment buckle.
USE and MAINTENANCE
09-16 Libretto TEC JET70'S ENG:Layout 1 8-06-2011 11:42 Pagina 12