SUOMY Jet 70s - Manual (Page 14)

USER’S INSTRUCTIONS
ENG
13
MICROMETRIC ADJUSTMENT RESTRAINT SYSTEM - see figure 2
Closing the strap - there are eight strap positions which make it possible to easily adjust the
restraint closure system, depending on the shape of the user’s head.
Push (X) the plastic lug (A) into the guide (B) until the strap is fully secured and pushes firmly against
the jaw. Once closed pull the strap firmly to check it has been secured correctly. If it is not secured
correctly adjust the length of the strap by moving (z) the band in the buckle (C). Repeat this operation
until the retention system is tightened correctly.
Releasing the strap - disengage the plastic lug (A) by pulling (Y) the fabric edge (D) positioned on the
lug (B). Release the strap and slip off the helmet.
REMOVABLE CHEEK PADS - see figure 3
Removal - Even if not used directly inside the cheek pad, it is better to release the restraint system as
described previously, before proceeding to remove the cheek pads. Carefully (X) pull the cheek pad to
the inside of the helmet until the first automatic clasp is released (A); repeat the procedure for the other
two clasps (B & C) until they are fully released and the cheek pad is removed.
Assembly - To re-assemble the cheek pad, first line up the innermost automatic clasps (B and C) and
exert light pressure until they are fully attached (heard with a click). Do the same with the third clasp (A).
Check the cheek pad is firmly fixed to the helmet.
REMOVABLE INNER HEAD CASING - see figures 4
SUOMY JET 70’s has been designed and approved for use with the cheek pad and head casing unit
fitted; the removal of this item should only be carried out for its replacement and/or maintenance.
At no time should the SUOMY JET 70’s product be used without these items being fitted correctly, in
accordance with that outlined in the following sections. Suomy cannot therefore be held responsible for
any direct or indirect damage resulting from the use of the product without these items fitted.
Removal - The internal casing is fitted to the shell with automatic fasteners positioned at the rear and
a strap system at the front of the helmet. To remove the casing it is therefore necessary to first release
figure 4
figure 2
figure 3
B
A
A
C
B
A
D
Y
Z
X
X
B
X A
C
B
09-16 Libretto TEC JET70'S ENG:Layout 1 8-06-2011 11:42 Pagina 13