Thermo Fisher Scientific CyberScan PC 300 User Manual
Page 32
Instruction Manual PC 300
28
6 H O L D
F UN C T I O N
This feature lets you freeze the display for a delayed observation. HOLD can be used any time
in MEAS mode.
1.
To hold a measurement, press the HOLD key while
in measurement mode. “HOLD” will appear on the
display.
2.
To release the held value, press the HOLD again.
Continue to take measurements.
NOTE:
•
This meter shuts off automatically after 20 minutes of last key press.
•
If the meter is shut off either automatically or manually, the HOLD value will be lost.
•
Your meter has an auto endpoint feature. When this feature is switched on, and
when a reading is stable for more than 5 seconds, the display will automatically
“HOLD” the reading. The “HOLD” indicator appears. Press the HOLD key to release
the reading. To switch on or off the auto endpoint feature, see SETUP program P3.1
in Section 7.4 for pH and SETUP, program P7.1 in Section 7.8 for conductivity/TDS.
Figure 24 - HOLD function