Thermo Fisher Scientific CyberScan PC 300 - Manual (Page 48)

Instruction Manual PC 300
44
P7.2 Selecting °C or °F
You can select between
°C and °F units for temperature
readings. Meter default is °C.
From measurement mode
7. Press the MODE key to select conductivity
measurement mode.
8. Press SETUP key to enter Set Up mode.
9. Press the or keys to scroll through subgroups
until you view parameter P7.0.
10. Press the ENTER key two times to select parameter
7.2.
11. Press the or keys to toggle between
°C and °F.
12. Press the ENTER key to confirm selection and to
proceed to step 3 of P7.3. Press the CAL/MEAS
key to return to measurement mode.
See Figure 37.
NOTES:
•
You can switch between °C and °F in Program P3.3 (available from pH mode). If you
switch between °C and °F in conductivity mode, the meter will also switch in pH mode.
Figure 37 - Change Temperature
measurement unit