Thermo Fisher Scientific CyberScan PC 300 - Manual (Page 43)

Instruction Manual PC 300
39
P3.4 Selecting °C or °F
This meter lets you select between °C and °F units for
temperature readings.
From measurement mode
1. Press the MODE key to select pH measurement
mode.
2. Press SETUP key to enter Set Up mode.
3. Press the or keys to scroll through subgroups
until you view parameter P3.0.
4. Press the ENTER key four times to select parameter
3.4.
5. Press the or keys to toggle between °C and
°F.
6. Press the ENTER key to confirm selection and to
return to the subgroup menu. Press the CAL/MEAS
key to return to measurement mode.
See Figure 31.
NOTES:
•
You can switch between °C and °F in Program P7.2 (available from conductivity or TDS
mode). If you switch between °C and °F in pH mode, the meter will also switch in
conductivity or TDS mode.
Figure 31 – P3.4: Select
temperature units
SETUP
C
p 3.4 °C
SETUP
F
p 3.4 °F
EN TER
RA NG
E