West Control Solutions KS 800 Operating Instructions - Manual (Page 26)

Multi-Temperature-Controller KS 800
8 Digital interfaces
Communication with controller KS 800 is possible only via the digital interfaces. Reading process
values, changing set-points or control parameters is always done via these interfaces.
There are two types of interfaces:
8.1 Engineering tool interface
The PC interface is provided on all controller versions. This interface is a special interface using the
ISO 1745 protocol. Access to all controller values is possible using the relevant software, the engi-
neering tool. E.g. for simple applications or test circuits, an individual unit can be configured and the
control loops can be operated normally via this interface.
Connection is to the 4/4 FCC68 data connector (Western telephone connector) via a special
PC adaptor, order no. 9407 998 00001.
8.2 BUS interfaces
This interface is used for connecting the KS 800 to a PLC, a PC or a visualization unit. Dependent
of version, the interface is designed for CANbus, CANbus with DeviceNet-protocoll, Profibus or as
RS 422/485 (see section 2.1). The 9-pole sub-D connector and socket are equivalent. They are
used for "through-connecting" the bus with several connected controllers.
See also page 8: Bus connectors
8.2.1 BUS-Connector
Con-
tact
Profibus CANbus RS422/485 DeviceNet
1 n.c. n.c. n.c.
See chapt. 8.2.2
"DeviceNet-Adaptor"
2 n.c CAN-L GND
3 n.c.RxD/TxD-P CAN-GND TXD-B
4 DGNC n.c. RXD-B
5 n.c. n.c. RGND
6 Vp(+5V) CNA-GND n.c.
7 n.c. CAN-H GND
8 RxD/TxD-N n.c. TXD-A
9 n.c n.c. RXD-A
26 9499 040 49111