West Control Solutions KS 800 Operating Instructions - Manual (Page 7)

Multi-Temperature-Controller KS 800
2.1.1 Possible output configurations
Provided that other criteria are taken into account, the following controller configurations are
possible:
Signaller with one output
Signaller with two outputs
Two-point controller (heating switching)
Three-point controller (heating switching, cooling switching)
Three-point controller (heating continuous, cooling switching)
Three-point controller (heating switching, cooling continuous)
Three-point stepping controller (without position feedback)
Continuous controller
Split-range controller (heating and cooling continuous, 0...100% each; max. 4 controllers)
Three-point controller with watercooling (water vaporization)
Limitter with latch function
When configuring a controller output as a continuous output, the relevant switching output is firmly
assigned to 0% duty cycle.
With unused analog outputs, the output variable is 0V or 0mA.
3 Installation
3.1 Mounting
KS 800 is provided for fast clip-on mounting to "top hat" standard rails 35 x 7,5 to EN 50 022,
EN 50 035 and EN 50 045.
KS 800 earthing is via a spring to the "top hat" rail. Therefore, this rail must have a good, conduc-
ting connection with the grounded mounting wall (layer of lacquer, non-conducting mounting wall,
Eloxal, ...). If necessary, the "top hat" rail must be earthed using a separate connection.
Single unit: For mounting, pull the two latches on the sides upwards by approx. 5 mm via a click
point and snap on the unit to the mounting rail. Press these latches down to lock the unit in position
on the rail.
9499 040 49111 7