West Control Solutions KS 800 Profibus Interface Manual - Manual (Page 27)

5.2 CODE tables
5.2.1 Structure of configuration words (C.xxxx)
The configuration words given in the following code tables comprise several partial components, which can
be transmitted only in common.
The data in the table must be interpreted as follows:
Example (C100): Code Descr. R/W Type Description Range
71 C100 R/W INT CFunc: Controller function
WFunc:Set-point function
(T,H)
(E)
0..xx0z
Description CFunc WFunc
Thousands Hundreds Ones
Range
x x z
00 ... 07 0...1
Example: 2-pnt. controller;
Set-point / cascade
0 2 0 4
g
- For transmission of configuration words, see chapter page 19.
- The possible settings of the configuration words are given in the KS800
function description (order no.: 9499 040 49218)
5.2.2 INSTRUMENT (FB no.: 0 type no.: 0)
All data which are valid for the overall instrument are grouped in function block ‘INSTRUMENT’.
Process data
General (Function no.: 0)
Code Descr. R/W Type Description Range Rem.
01 Unit_State 1 R ST1 Status 1 A
10 Block 13..15, 18 R Block
13 Write Error R INT Error during last write access 0, 100...127
14 Write Error
Position
R INT Position of last write access error 0...99
15 Read Error R INT Error during last read access 0, 100...127
16 DPErr R ICMP Error messages from DP module B
17 DPAdr_eff R INT Effective PROFIBUS address 0...126
18 Type R INT Type no. of function block 0
20 Block 21...27 R Block
21 HWbas R INT Basic HW options: module A, P C
23 SWopt R INT SW options 1 D
24 SWcod R INT SW code no. 7th-10th digit of 12NC wxyz E
25 SWvers R INT SW code no. 11th-12th digit of 12NC 00xy F
26 OPVers 1) R INT Operating version
27 EEPVers 1) R INT EEPROM version
31 OpMod R/W INT Instrument switch-over to configuration mode (only after 1) 0
Instrument switch-over to online mode (only after 0) 1
Cancellation of configuration mode (only after 0) 2
32 Ostartg R/W INT Stop/start self-tuning for all group controllers 0..1
33 UPD R/W INT Acknowledgement of local data change 0..1 G
34 HC_reset R/W INT Heating-current-reset / Quicktest 0...3 G2
27 9499 040 50511
Function block protocol
1) Data are reserved for distinction of internal versions in future applications.