Product assembly – Badger Meter GALAXY User Manual
Page 10
Advertising
GALAXY® Gateway Receiver 3.0 Fixed Network
PRODUCT ASSEMBLY
NOTE:
N
In the event that you connect the power / communications cable to the receiver on the ground prior to installation,
this step would precede mounting the gateway to the pole .
To connect the power / communications cable to the receiver:
1 . Unscrew the four captive screws securing the receiver cover .
Figure 5: Captive Screws
2 . Insert the power / communications cable through the cable gland on the bottom of the receiver housing .
Figure 6: Cable Gland
3 . Strip the outer cable jacket to a length of two to three inches .
Figure 7: Outer Cable Jacket
Screws
Screws
Cable Gland
Outer Cable Jacket
Page 10
January 2013
Advertising