Badger Meter GALAXY - Manual (Page 9)

Installation & Operation Manual
3 . Tighten BAND-IT ties with one of these (listed in order of increasing tension):
a . By hand
b . BAND-IT AE201 Tensioning Hook
c . BAND-IT AE200 Tensioning Tool
d . BAND-IT C075 Bantam Tool
Figure 4: Tightening BAND-IT Ties
4 . Bend tail back over raised bridge .
5 . Secure tail under ears by slightly pushing the tail sideways and down, first one way then the other (tail may be left on
for re-use) .
NOTE: N Hammering down the bridge may increase the strength of the lock, but will not allow the clamp to be re-used .
Page 9 January 2013