Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 10)

ORION® Fixed Network (SE) II Network Gateway Transceiver
Tttach the Backhaul Tntenna
1 . Remove the plastic cover from the Type N female connector on the backhaul antenna bracket .
2 . Remove the backhaul antenna from the carton .
3 . Thread the Type N male connector (antenna) onto the Type N female connector on the backhaul antenna bracket .
NOTE: N See "Backhaul Antenna Bracket" on page 13 for additional mounting information .
4 . Hand tighten until finger tight . Then use pliers or a strap wrench to tighten an additional 1/16 inch turn (maximum) .
Do not over-tighten or the connector can be damaged .
GPRS Only – Install the SIM Card (Customer-supplied)
A SIM card provides access to the cellular
provider network for the GPRS backhaul .
To install, slip the SIM card into the slot on
the green GPRS module, inside the enclosure,
on the gateway transceiver circuit board . An
outline of the SIM card is shown above the
slot (Figure 3) . The outline shows the SIM card
notch on the left side .
Push the card into the slot (with the notch on
the left side) as far down as it will go . The SIM
card should look like the photo in the inset
circle when installed correctly .
Figure 3: SIM card slot
Insert SIM Card
Into Slot
Page 10 March 2014