Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 16)

ORION® Fixed Network (SE) II Network Gateway Transceiver
NOTE: N Installation of banding mounting requires the use of the BAND-IT tool shown below (66042-006) or equivalent
BAND-IT tool as recommended by BAND-IT .
Figure 14: BAND-IT tool
1 . Locate the BAND-IT tool and supplied installation instructions .
2 . Follow the BAND-IT-supplied installation instructions enclosed with the BAND-IT tool for attaching the gateway
transceiver to a pole .
3 . Using a 1/2 inch wrench, apply the recommended torque for the 5/16-24 screw that attaches the gateway bracket to
the BAND-IT banding . The recommended torque is 144…168 inch-pounds (12…14 foot-pounds) .
Figure 15: Gateway shown with BAND-IT mounting hardware
Page 16 March 2014