Badger Meter ReadCenter - Manual (Page 67)

Historical Readings
The example shown above displays the collected readings when the Historical Reads schedule is run Multiple readings for a
single endpoint are displayed for the date listed The Primary boxes are not checked and no usage and exception conditions
are shown on this screen
Column Headings
The following headings display in the first three columns in the Readings section of the Collected Readings screen
Endpoint Serial # Unique serial number of the endpoint
Read Date Date and time of the meter reading
Read The actual (raw) meter reading collected at the date and time specified
Usage and exception conditions reported by the endpoint are listed across the top of the screen in the Readings section A
check mark in the box indicates a condition that existed at the time of the meter reading
OTE: N Refer to "Reports" on page 30 for additional information
Program Endpoint received a program parameter change For example, it was reprogrammed via IR
Device Conditions indicated in extended status See “Device“ under "Status" on page 29.
Tamper Endpoint reporting a tamper condition
Reverse Endpoint reporting that the encoder measured flow in the reverse direction
No Use Endpoint reporting no usage
Leak Endpoint reporting a potential leak condition
Low Batt Endpoint reporting that its estimated battery life is low
Primary The Primary indicator is only checked for the endpoint current reads Current reads are collected when
the Current Reads schedule runs
Number of
gateways
Number of
readings
User Manual
Page 67 June 2014