Badger Meter Model IOG - Manual (Page 12)

REGISTER PROGRAMMING
In programming mode only, pressing and releasing the TOTAL button advances to the next parameter on the current screen
Pressing and releasing the RESET button changes the current flashing selection to another selection (such as “L” to “GAL”)
To enter the programming mode: Press the TOTAL button three times and then press the RESET button three times (the time
lag between pressing both buttons six times must be within two seconds)
Changing the Unit of Measure
(For models ILR 700, 710, 720 and 730)
Figure 5E: Unit of Measure & Scale Factor Programming
1 Press and release the RESET button to change the unit of measure (L, GAL, QT, PT)
2 Press and release the TOTAL button to select desired the unit of measure (the selected unit of measure will flash)
3 When the appropriate unit of measure is selected, press the TOTAL button to advance to the
scale factor programming
Changing the Scale Factor
(For models ILR 700, 710, 720 and 730)
The register collects input pulses from the oval gear meter and then determines the appropriate display output using the
scale factor This scale factor varies depending upon the viscosity of the liquid being measured, therefore calibrating the
meter and register in the appropriate liquid will affect the scale factor The scale factor is displayed as 5 digits (on the top row)
next to the unit of measure The scale factor consists of 1 integer digit and 4 decimal digits (see Figure 6)
1 Press the TOTAL button to select a digit (selected digits flash) After cycling through all 5 digits of the scale factor, the
register will return to the unit of measure selection
2 Press RESET to change the selected digit The scale factor must fall between the values of 0 5000 and 2 0000 The
Badger Meter factory preset is set between those values at 1 0000
3 When you are finished adjusting the unit of measure and scale factor, press and hold the TOTAL button for one
second to advance to the Pulse Rate section
OTEE: N Error checking will not allow the user to advance to the next screen
Industrial Oval Gear Meter and Register
Page 12 May 2013