Sterlco GH-M Series Extrusion Control Weigh Hoppers - Manual (Page 50)

Chapter 7: Appendix 50 of 60
7-2 Addendum (Service Supervisor Information)
Caution! After all selections are made: Keep pressing the “Done” key until the unit
returns to the Recipe menu.
Passwords
• User Password
“5413”
• Maintenance Password
“3145348”
Caution! Maintenance password should only be supplied to qualified personnel!
The program can be compromised.
Programmable Settings
The rate monitor software program has been designed to allow some customizing to achieve
certain desired operating parameters. The following is a listing of the selections that are
“field” programmable, followed by the procedure for doing so.
Pressing the manufacturer’s icon when in the “Setup” Directory Screen menu accesses this
menu.
Figure 67: Typical Operator Setup Screen
Note: Untrained personnel of the rate monitor controller, should not use this
section of the manual and/or program can be compromised!
Note: Hidden, programmable features and hidden menu pages should not be
made available to floor operators. These pages include the Service
Supervisor Information addendum located in this section. Unauthorized
changes to these factory settings by inexperienced operators may
prevent the unit from operating properly, and may void part or all of the
warranty.
Note: Inexperienced operators or inexperienced plant personnel should not
access programmable features. Unauthorized changes may prevent the
rate monitor from operating properly and may void part or all of the
warranty.
Note: Call the Service Department for assistance or for further explanation of
these or any other programmable features, which may or may not be
shown in this manual.
Note: Information included in this manual is subject to change without notice.
Touch this icon and
enter in the Service
Password to access
the Engineering Only
Directory