Brother Innov-is V5 - Manual (Page 302)

ERROR MESSAGES
A-36
This USB media cannot be used. This message is displayed when you try to use incompatible
media.
This USB media is incompatible. This message is displayed when you try to use incompatible
USB media. For a list of compatible USB media, visit
“ http://solutions.brother.com ”.
Transmitting by USB This message is displayed while the USB media is
transmitting.
Turn off the power and replace the needle plate. This message is displayed when you try to sew with a stitch
other than a middle needle position stitch while the single-hole
needle plate is installed.
This message is displayed when the needle plate is removed
with the machine on or when the machine is turned on and
“Embroidery” or “Embroidery Edit” mode is selected (see page
B-20).
USB media error This message is displayed when an error occurs with the USB
media.
USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a
pattern while no USB media is loaded.
Use the presser foot lifter button to lower the presser foot. This message is displayed when a button, such as the
“Start/Stop” button, is pushed while the presser foot is raised.
When the speed controller is set to control the zigzag stitch
width, the "Start/Stop" button does not operate. This message is displayed when the speed control lever is set
to control the zigzag stitch width, and the “Start/Stop” button
is pushed. Use the foot controller to operate the machine.
Marks Error Messages Cause/Solution