Brother Innov-is V5 - Manual (Page 60)

BEFORE EMBROIDERING
B-58
g
Hold the embroidery foot in place with
your right hand, and then use the included
screwdriver to securely tighten the presser
foot holder screw.
h
Press to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
Using the Optional Embroidery
Foot “W+” with LED Pointer
By plugging in the connector on the back of your
machine, the embroidering needle drop point will
be indicated on the fabric, allowing you to
accurately position the pattern.
■ Attaching the Embroidery Foot
“W+” with LED Pointer
a
Follow the steps from
a
to
e
of
“Attaching the Embroidery Foot “W”” on
page B-57.
b
Position the embroidery foot “W+” with
LED pointer on the presser foot bar by
aligning the notch of the presser foot to the
large screw.
Side view
c
Hold the embroidery foot in place with
your right hand, and then use the included
screwdriver to securely tighten the presser
foot holder screw.
d
Plug the connector of the embroidery foot
“W+” with LED pointer into the jack on the
back of your machine.
e
Press to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
CAUTION
• Use the included screwdriver to firmly tighten
the screw of the embroidery foot. If the screw
is loose, the needle may strike the presser foot
and possibly cause injury.
CAUTION
• When attaching a presser foot, always press
on the screen. You may accidentally
press the “Start/Stop” button and possibly
cause injury.
• Be sure to use embroidery foot when doing
embroidery. Using another presser foot may
cause the needle to strike the presser foot,
causing the needle to bend or break and
possibly cause injury.
CAUTION
• Use the included screwdriver to firmly tighten
the screw of the embroidery foot. If the screw
is loose, the needle may strike the presser foot
and possibly cause injury.