Brother Innov-is V5 - Manual (Page 40)

LOWER THREADING
B-38
f
Pass the thread around the pre-tension disk
making sure that the thread is under the
pre-tension disk.
a Pre-tension disk
→ Make sure that the thread passes under the
pre-tension disk.
b Pre-tension disk
c Pull it in as far as possible.
→ Check to make sure thread is securely set between
pre-tension disks.
g
Wind the thread clockwise around the
bobbin 5-6 Times.
h
Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread to the right to cut the thread with
the cutter.
a Guide slit (with built-in cutter)
b Bobbin winder seat
i
Set the bobbin winding switch to the left,
until it clicks into place.
a Bobbin winding switch
→ The bobbin winding window appears.
CAUTION
• Be sure to follow the process described. If the
thread is not cut with the cutter, and the
bobbin is wound, when the thread runs low it
may tangle around the bobbin and cause the
needle to break.
Memo
• Sliding the bobbin winding switch to the left
switches the machine into bobbin winding
mode.