Brother Innov-is V5 - Manual (Page 68)

USING FUNCTIONS BY CONNECTING THE ACCESSORY TO THE MACHINE
B-66
Attach the sole by aligning the pins with the notches
and snap it into place.
a Pins
b Notches
■ Using the Dual Feed Position Lever
When the feed position lever is up, the black roller
belt on the dual feed is not engaged.
When the feed position lever is down, the black
roller belt on the dual feed is engaged.
■ Adjusting the Amount of Fabric
Feeding of the Dual Feed Foot
The dual feed mechanism pulls the top fabric
according to the set stitch length. With troublesome
fabrics, fine tune the set length, by changing the
dual feed feed adjustment in the settings screen.
a
Press .
→ The settings screen appears.
b
Press .
→ The Sewing settings screen appears.
c
Display page 1 of the Sewing settings
screen.
d
Use or to increase or decrease the
feeding of the top fabric.
* Select “00” for sewing in most cases.
* If the feed amount for the top fabric is too little,
causing the fabric to be longer than the bottom
fabric, press to increase the feed amount for the
top fabric.
* If the feed amount for the top fabric is too much,
causing the fabric to be shorter than the bottom
fabric, press to decrease the feed amount for the
top fabric.
e
Press to return to the original screen.
Note
• Do not operate the lever while sewing.
Note
• As a default, some keys mentioned in the
following procedures appear in light gray
and are not available. To enable the keys for
specifying the settings, attach the dual feed
foot to the machine. The keys are enabled
after the dual feed foot is detected.