Brother Innov-is V5 - Manual (Page 58)

BEFORE EMBROIDERING
B-56
Embroidery Step by Step
Follow the steps below to prepare the machine for embroidery.
BEFORE EMBROIDERING
Step 3
Step 1, 2
Step 7
Step 5
Step 4
Step 6, 8
Step 9
Step # Aim Action Page
1 Presser foot attachment Attach embroidery foot “W” or “W+”. B-57
2 Checking the needle Use needle 75/11 for embroidery. * B-54
3 Embroidery unit attachment Attach the embroidery unit. B-60
4 Bobbin thread setup For the bobbin thread, wind embroidery bobbin thread and set it in place. B-36
5 Fabric preparation Attach a stabilizer material to the fabric, and hoop it in the embroidery frame. E-11 to
E-17
6 Pattern selection Turn the main power to ON, and select an embroidery pattern. E-3
7 Embroidery frame attachment Attach the embroidery frame to the embroidery unit. B-60
8 Checking the layout Check and adjust the size and position of the embroidery. E-19
9 Embroidery thread setup Set up embroidery thread according to the pattern. E-21
* It is recommended that a 90/14 needle should be used when embroidering on heavy weight fabrics or stabilizing products (for example;
denim, puffy foam, etc.). Ball point needle (golden colored) 90/14 is not recommended for embroidery.