Brother Innov-is V5 - Manual (Page 71)

SEWING
Se
w
ing
B
as
ic
s
Sewing S-3
S
1
Sewing a Stitch
a
Turn the main power to ON and display the
utility stitches, and push the “Needle
Position” button to raise the needle.
b
Press the key of the stitch you want to sew.
→ The symbol of the correct presser foot will be
displayed in the upper left corner of the LCD screen.
c
Install the presser foot (“CHANGING THE
PRESSER FOOT” of “Basic operations”).
d
Set the fabric under the presser foot. Hold
the fabric and thread in your left hand, and
rotate the handwheel to set the needle in
the sewing start position.
e
Lower the presser foot.
* You do not have to pull up the bobbin thread.
f
Adjust the sewing speed with the speed
control slide.
* You can use this slide to adjust sewing speed during
sewing.
a Slow
b Fast
SEWING
CAUTION
• To avoid injury, pay special attention to the needle while the machine is in operation. Keep your hands
away from moving parts while the machine is in operation.
• Do not stretch or pull the fabric during sewing. Doing so may lead to injury.
• Do not use bent or broken needles. Doing so may lead to injury.
• Do not attempt to sew over basting pins or other objects during sewing. Otherwise, the needle may break
and cause injury.
• If stitches become bunched, lengthen the stitch length setting before continuing sewing. Otherwise, the
needle may break and cause injury.
CAUTION
• Always use the correct presser foot. If the
wrong presser foot is used, the needle may
strike the presser foot and bend or break,
possibly resulting in injury.
Refer to page S-67 for presser foot
recommendations.
Memo
• The black button on the left side of presser
foot “J” should be pressed only if the fabric
does not feed or when sewing thick seams
(see page S-8). Normally, you can sew
without pressing the black button.