Acer Altos R920 Series - Manual (Page 83)

65
7 Observe the post-installation instructions described on page 40.
To install the DVD drive:
1 Perform the pre-installation instructions described on page 39.
2 If necessary, remove the old DVD drive. See previous section.
3 Remove the new drive from its protective packaging.
4 Attach the SATA-to-IDE converter board to the new media device
(A).
5 Install the media device into the carrier (B).
6 Slide the carrier into the front opening in the chassis (C).
7 Plug the SATA and power cables into the converter board (D).
8 Observe the post-installation instructions described on page 40.