Brother SE-270D - Manual (Page 122)

116
EMBROIDERY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e
Loosen the presser foot holder screw and
remove the presser foot holder.
Turn the screwdriver toward the back.
a Screwdriver
b Presser foot holder
c Presser foot holder screw
X Remove the presser foot holder.
f
Set the bar on the embroidery foot onto the
needle clamp screw bar.
a Embroidery foot bar
b Needle clamp screw
g
Secure the embroidery foot with the presser
foot holder screw.
Set the embroidery foot perpendicular.
h
Tighten the presser foot holder screw.
Turn the screwdriver toward the front.
CAUTION
1
2
3
1
2
● Do not hit the needle with your finger or
the embroidery foot "Q" when attaching
it. The needle might break or cause injury.
● Be sure to tighten the screw with the
included screwdriver. If the screw is
loose, the needle might hit the presser
foot and break or bend.
● Before sewing, always turn the balance
wheel toward you slowly, and check to be
sure that the needle does not hit the
presser foot. The needle could be broken
or bent.