Brother SE-270D - Manual (Page 31)

Upper Threading 25
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
m
Pull the thread under the disc at the front in
the lower-left corner and around to the right,
and then the thread will be cut with the cutter.
Follow arrow 6 indicated on the thread
cassette.
a Disc
b Cutter
X The spool of thread is now loaded in the
thread cassette.
Note
z Be sure the thread is cut as described above,
otherwise the needle threader cannot be
used to thread the needle.
Threading the needle
In this section, the procedures for installing the thread
cassette and threading the needle are described. The
needle threader is used to thread the needle at the
same time that the thread cassette is inserted.
Memo
z The needle threader can be used with sewing
machine needles 75/11 through 100/16.
z Thread with a thickness of 130/20 or thicker
cannot be used with the needle threader.
z The needle threader cannot be used with the
wing needle or the twin needle.
z If the needle threader cannot be used, refer
to "Thread the needle manually (without
using the needle threader)" (page 28).
a
Check that the thread cassette indicator is lit
up in green.
a Thread cassette indicator
• If the thread cassette indicator is lit up in red,
the needle has not been raised to the correct
position. Press
(Needle position button)
once to raise the needle.
a Needle position button
• If the needle is not raised to the correct posi-
tion, the needle cannot be threaded with the
needle threader. Be sure to check that the
thread cassette indicator is lit up in green
before inserting the thread cassette.
1
2
1
1