Brother SE-270D - Manual (Page 22)

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
16
Winding/Installing the Bobbin
This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread.
Bobbin precautions
Be sure to observe the following precautions
concerning the bobbin.
CAUTION
Winding the bobbin
Wind the thread around the bobbin to prepare the
bobbin thread.
a
Turn on the sewing machine.
b
Open the bobbin winder cover at the top on
the right side of the sewing machine.
Raise until it stops with a click.
c
Swing up the bobbin thread spool pin.
Move the bobbin thread spool pin up as far as
possible.
a Bobbin thread spool pin
● Only use the Bobbin (part code: SA156,
SFB:XA5539-151) designed specifically
for this sewing machine. Use of any other
bobbin may result in injuries or damage
to the machine.
● The included bobbin was designed
specifically for this sewing machine. If
bobbins from older models are used, the
machine will not operate correctly. Use
only the included bobbin or bobbins of
the same type (part code: SA156,
SFB:XA5539-151).
● Please use a transparent bobbin.
11.5 mm
Actual size
This model Older model
(7/16 inch)
1