You prefer, While shooting, Lens retraction timing – Canon PowerShot G1 X Mark II User Manual
Page 172: Using eco mode, Power-saving adjustment
172
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode / Hybrid
Auto Mode
Other Shooting
Modes
P Mode
Tv, Av, M, C1, and
C2 Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
Lens Retraction Timing
The lens is normally retracted for safety about one minute after you press
the <
). To have the lens retracted
immediately after you press the <
1> button, set the retraction timing to [0 sec.].
z
z
Choose [Lens Retract], and then choose
[0 sec.].
Using Eco Mode
This function allows you to conserve battery power in Shooting mode. When
the camera is not in use, the screen quickly darkens to reduce battery
consumption.
1
Configure the setting.
z
z
Choose [Eco Mode], and then choose [On].
z
z
[
] is now shown on the shooting
screen (
z
z
The screen darkens when the camera
is not used for approximately two
seconds; approximately ten seconds
after darkening, the screen turns off.
The camera turns off after approximately
three minutes of inactivity.
2
Shoot.
z
z
To activate the screen and prepare for
shooting when the screen is off but the
lens is still out, press the shutter button
halfway.
Power-Saving Adjustment
Adjust the timing of automatic camera and screen deactivation (Auto Power
Down and Display Off, respectively) as needed (
).
z
z
Choose [Power Saving], and then press
the <
m> button.
z
z
After choosing an item, press the
<
q><r> buttons to adjust it as needed.
•
To conserve battery power, you should normally choose [On] for
[Auto Power Down] and [1 min.] or less for [Display Off].
•
The [Display Off] setting is applied even if you set [Auto Power Down] to [Off].
•
These power-saving functions are not available when you have set Eco mode
(
) to [On].