Canon imagePROGRAF iPF6400S - Manual (Page 108)

iPF6400S Basic Guide
108
Tro
ubl
esho
otin
g
P
rob
lem
s Reg
ard
ing Pap
er
2 Press ▲ or ▼ to select Manual Paper, and then press the OK button.
A menu for selection of the type of paper is displayed.
3 Select POP Board and press the OK button.
Instructions for feeding POP Board are now displayed on the Control Panel, but follow this
procedure to remove the jammed paper.
4 Open the Top Cover.
5 Fold an A4 sheet lengthwise four times and
insert it through the gap of the Back Cover. Push
the scrap out toward the Platen.
6 Remove the scrap when it is pushed out onto the Platen.
7 If any scraps remain inside the paper feed slot, repeat steps 5 and 6.
8 Close the Top Cover.
9 Turn the printer off. (See "Turning the Printer On and Off.")➔User's Guide
Cut sheets cannot be pulled out from the front paper feed slot
Cause Corrective Action
You have loaded
paper other than POP
board. Push the cut sheet from the front side of the printer towards the back side. Once the edge of the
cut sheet protrudes from the back side of the printer, pull it out from the back side.