Canon imagePROGRAF iPF6400S - Manual (Page 149)

iPF6400S Basic Guide
149
Er
ror M
essa
ge
Me
ssa
ges
r
egar
ding
pr
inti
ng
or
a
djus
tm
ent
Replace with a 16-inch wide or wider roll paper.
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet or
other printer status information.) Replace the roll with a roll 16 inches in width or larger as
follows.
1. Press
▲ or ▼ to select Change Paper, and then press
the OK button.
(See "Removing the Roll from the Printer.")➔P.17
(See "Removing Rolls From the Roll Holder.")➔User's
Guide
2. Replace the roll with a roll 16 inches wide or larger.
(See "Loading Rolls on the Roll Holder.")➔P.12
(See "Loading Rolls in the Printer.")➔P.14
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the
OK button.
Cannot calibrate.
Cause Corrective Action
The paper for printing a test pattern is soiled. Otherwise,
you have loaded colored paper. Press the OK button to clear the error.
Load unused paper compatible with color calibration.
(See "Paper Reference Guide.")
The test pattern was printed too faintly. Press the OK button to clear the error.
Take steps to remedy faint printing.
(See "Printing is faint.")➔P.113
Direct sunlight or strong lighting may be shining on the
printer and causing the sensor to malfunction. Press the OK button to clear the error.
Take steps to ensure the printer is not used when exposed
to direct sunlight or strong lighting.
Excessive temperature or humidity.
Cause Corrective Action
The temperature or humidity
where the printer is installed is out
of the acceptable range for
operation. Press ▲ or ▼ to select Stop, and then press the OK button to stop printing.
Use the printer under suitable environmental conditions. Also note that various
environmental conditions are recommended for various types of paper. For details on
the recommended environmental conditions, see the Paper Reference Guide.
(See "Paper Reference Guide.")
Please execute common calibration.
Cause Corrective Action
There is not even one Common calibration execution result.
Note that this is displayed when all of the following are satisfied.
• If
Set Exec. Guide is On in the Control Panel menu.
• If the printer is loaded with a type of paper on which color calibration
cannot be executed.
Execute Common calibration.
(See "Color Calibration Using the Printer
Sensor.")➔User's Guide
Set Set Exec. Guide to Off on the
Control Panel menu.
(See "Menu Structure.")➔P.66