Canon imagePROGRAF iPF6400S - Manual (Page 17)

iPF6400S Basic Guide
17
Handl
ing
P
ape
r
Ha
ndl
ing
r
oll
s
Note
• For details on types of paper to select, see the Paper Reference Guide. (See "Paper
Reference Guide.")
7 Close the Roll Feed Unit Cover.
Important
• Cut the edge of the roll using the Paper Cutting function if the edge is creased or
soiled. (See "Specifying the Cutting Method for Rolls.")➔User's Guide
Note
• Adjusting the printhead alignment with the type of paper to be used in printing may
enhance printing quality. (See "Automatic Adjustment to Straighten Lines and Colors.")
➔
P.97
• If you set the detection of paper leading edge to Do not perform, a margin of about 23
cm is created at the paper leading edge when printing starts.(See "Specifying the
Cutting Method for Rolls.")➔User's Guide
Removing the Roll from the Printer
Remove rolls from the printer as follows.
Important
• Once a roll has been advanced, do not pull the paper out by force. This will prevent further
feeding, and the printer will be unable to keep track of the amount of roll paper left.
If you accidentally pull out paper, follow these steps to remove the roll, and open the paper
feed slot.
Note
• If you need to cut the roll, see "Specifying the Cutting Method for Rolls."➔User's Guide
• The operations for a printer with a Spectrophotometer Unit (option) are the same as for a
printer with no Spectrophotometer Unit (option). If it is difficult to remove from the front of the
printer, lowering the Up-down Unit may make the operation easier from the front of the
printer.(See "Lowering the Up-down Unit of the Spectrophotometer Unit (option) Manually.")➔
P.19
1 On the Tab Selection screen of the Control
Panel, press
◀ or ▶ to select the (Paper
tab) .